French Artillery - Crew 1807-1811 28mm

STL files for French foot artilley crew 1807-1811 uniform for 28 mm miniatures.

Note that scale up or down may result in not to scale and fragile parts such as tools.

Figures are presented with the romboidal shako plate and the An X cartridge pouch model.

This set includes 25 files as described below:

•  Rammer
  • 3 pre-supported figures with different ram sizes.
  • 3 unsupported figures with different ram sizes.
  • 1 pre-supported assemble tool figure with ram and mop tips.
  • 1 unsupported assemble tool figure.
  • 1 unsupported ram and mop tip.
• 1 Wormer
  • 3 pre-supported figures with different worm sizes.
  • 3 unsupported figures with different worm sizes.
  • 1 pre-supported assemble tool figure with worm tips.
  • 1 unsupported assemble tool figure.
  • 1 unsupported worm tip.
• 1 Firer
  • 1 pre-supported figure with linstock.
  • 1 unsupported figure.with linstock
  • 1 pre-supported assemble tool figure with worm tips.
  • 1 unsupported assemble tool figure.
  • 1 unsupported linstock tip.
• 1 Carrier
  • 1 pre-supported figure.
  • 1 unsupported figure.

Figures are presented with supports and without supports.

Pre-supported figures hava a minimal support structure both to minimize supporting points in the figures to keep them as clean as possible to preserve details and to save printing material to reduce the printing cost. We do recommend to print using semi flexible resin.

As artillery tools are thin pieces we present the option to print the figures without the tools. for such purpose figures come with wholes in their hands to insert the tools.

The tip of the tools are presented separately in the pre-supported files and in separate files for the unsupported figures.It is convenient to use a 2k or higher resolution printer as the tips have small wholes in them to mount the metlic rods.

A metalic rod (such as those available for model railroads) has to be inserted into the tips.Sizes for the tips are the following.

• Linstock: 0.5mm
• Ram: 0.8mm
• Worm 0.8mm

You must cut the ram and worm rods in different lenghts depending on the cannon caliber they will be serving based on this orientative table:

• 4 pounds cannon 29mm
• 8 pounds cannon 37mm
• 12 pounds cannon 42mm

Figures with the printable tools come in three different tool sizes to fit the requirements of the 4pdr, 6pdr and 12 prd cannons.

Every item is presented in a separate file for your sliceing and printing convenience.

Files are presented with supports and without supports as indicated above.

We recommend the use of side cutters and cutter to remove the supports.