Italian Artillery 12p & 6p An XI cannons with crews 28mm STL

STL files for the An XI Ordnance field guns with Kingdom of Italy monogramed tubes and crews and accessories for 28 mm miniatures.

Note that scale up or down may result in not to scale and fragile parts such as handles, wheels spokes, etc.

An XI Ordnance removed the trail handles on the carriages. Thye were later added as they were very usefull to aim the cannons. Here we present the two versions.

Artillery of the Kingdom of Italy had a peculiar peakless shako and shoulder straps with two buttons,

This set includes files for

• 2 cannons
• 4 gunners in different uniforms
• 2 EXTRAS
  • 3 gabions
  • 1 barrel

• 6-pdr cannon (with supports and without supports)
  • Carriage.
  • Carriage with handles.
  • Kingdom of Italy monogram 6pdr tube.
  • 2 152,5 cm wheels at 28 mm scale (right wheel and left wheel).
  • 2 trunnion locks..

• 12-pdr cannon (with supports and without supports)
  • Carriage.
  • Carriage with handles.
  • Kingdom of Italy monogram 12pdr tube.
  • 2 trunnion locks.

Note: The 12 pdr cannon has the same 152,5 cm wheels than the 6pdr cannon, the same files has to be used.

Accessories

• Ammunition box 6 pdr (with supports and without supports)
• Ammunition box 12 pdr (with supports and without supports)
• 3 water buckets.(no supports needed)
  • Close with vertical handle.
  • Close with horizontal handle.
  • Open with horizontal handle and lid aside.

This set includes four different sets of the foot artillery uniform as depicted by drawing at the library of the Museo del Risorgimento at Milano, with  25 files each  as described below:

1. Foot Artillery uniform.
2. Foot Artillery with forge cap.
3. Foot Artillery in long trousers.
4. Foot Artillery in long trousers with forge cap

•  Rammer
  • 3 pre-supported figures with different ram sizes.
  • 3 unsupported figures with different ram sizes.
  • 1 pre-supported assemble tool figure with ram and mop tips.
  • 1 unsupported assemble tool figure.
  • 1 unsupported ram and mop tip.
• 1 Wormer
  • 3 pre-supported figures with different worm sizes.
  • 3 unsupported figures with different worm sizes.
  • 1 pre-supported assemble tool figure with worm tips.
  • 1 unsupported assemble tool figure.
  • 1 unsupported worm tip.
• 1 Firer
  • 1 pre-supported figure with linstock.
  • 1 unsupported figure.with linstock
  • 1 pre-supported assemble tool figure with worm tips.
  • 1 unsupported assemble tool figure.
  • 1 unsupported linstock tip.
• 1 Carrier
  • 1 pre-supported figure.
  • 1 unsupported figure.

EXTRAS

• Gabions
  • Short (16.5 mm)
  • Tall (25.5 mm)
  • Extra tall (28 mm)
• Barrel

We recommend the use of side cutters and cutter to remove the supports.